How to remove / replace alarm door contact sensor

How to remove / replace alarm door contact sensor

To replace an alarm door contact, first you need to unscrew the contact using the two screws You then need to disconnect wires from back of cont

Engineer reset required – ADT Honeywell Galaxy alarm problem
How to change Scantronic 9448 alarm code
Common Honeywell Accenta / Optima Alarm problems: how to fix

To replace an alarm door contact, first you need to unscrew the contact using the two screws

You then need to disconnect wires from back of contact – either 2 or 4 wires depending on whether there’s a tamper circuit wired in. Please note, if a tamper is wired, then this will set the alarm off. To silence the alarm, enter 4 digit code.

Still, need help?

If you still need help with your alarm, then get in contact with our team to see if we can help you >>

Burglar alarm Tech support

Or if you know you need an engineer then book an ‘on-site visit’ where one of our trained engineers comes out to your site to fix your problem.  Book an engineer visit here  or email us at help@smartsecurity.support

Book alarm engineer visit